Instrukcja montażu, konserwacji i obsługi Asus Bm5295

Subskrybuj nasze sieci społecznościowe, aby być na bieżąco z najnowszymi aktualizacjami!

Komentarz

Hi. Great video. Have 2 questions. We just visited your website and noticed that you do tinker around with z-wave products. We implement a lot of 2GIG products, and for the most part, new installs are a breeze. But when taking over existing wired systems, we need to install 2GIG's takeover module. Keeping the current wired install in place, 2GIG's Takeover Kit requires only the zone wire to be removed, and leaving the COM still in the wired system.

In the future, make sure to mention that the two-wire smoke circuit (zone 1) is polarity sensitive.

Also, instead of purchasing a new terminal block you can just run all wires and connect them using a wire nut and run a single wire per terminal on the keypad bus.

Can you add an outside key pad with this system?

Why are you not using "fire wire" I would useing terminal 9.The fire wire is a bit expensive but it fuses in heat and which in turn sets off the fire alarm. As you know Fire over rides burgular

Is the long horn smoke detector or the other model of smoke detector can applicable to honeywell panel?or not?how can install it,specially in four wires?

My smoke alarms are wireless. How do I silence the "Fire Trouble" error I get in my Tuxedo Keypad? Do I just connect 2k resistors across the board terminals for zones that are not wire connected?

Great video.

Hello Jon.....I just moved in to a house using this exact system. I have a 2nd GE keypad at my interior garage door entrance that for some reason is disconnected at the box. I have a black ,green and white wire in the box not connected. May I ask which terminals these should be connected to. I did as much research as possible to determine why this was disconnected with no result. I need to find out for myself.

Hello; I am a subscriber, and owner of a Honeywell Vista alarm panel. Would you please answer a question for me? If the Vista panel alarm goes off, and the perp leaves an alarmed door open, how long will the alarm go off without a code being entered to disarm it?

I have a Vista 10SE System with 2 key pads, 3 door contacts and want to add 7 FG-1625 acoustic glassbreaks. The wiring is all done through out the first floor behind the walls to the control panel and labeled. I don't have enough zones left to keep them separated so do I need to bundle them with a terminal block?

What will happen if I wire a motion detector with the resistor connecting across the MOTION TO PANEL and MOTION FROM PANEL

Hi, I want to wire a panic button to the panel, can you tell me where should I connect to?

So it doesn't matter if the resistor goes on the high or low side of the zone terminals in the panel? I was watching another video that said to always put it to the gnd or low side???

8worked for Honeywell .Yes a certified electronic alarm system techni ian

Do I need resistors for a fire alarm? Where do I put in several spectralert classics?

Can you have a door contact on zone 1 and then in programming you set it as a entry delay and exit delay?

Is it hard to replace a door contact

Good lord. Someone go to that DSC keypad and hit *2.

I have a problem with Honeywell Vista 20P.

.

Zostaw komentarz

#0